Chapter 5 – Setting Country or Region Codes Using the CLI
Chapter 5 – Setting Country or
Region Codes Using the CLI
The Default Country or Region Code is B5.
If You Want to Change the Country or Region Code, Use the Command Line Interface:
Command Syntax | set serial s1 modem |
Description | Sets the modem country/region code value to <value>. |
| This command is valid only for port s1. Applicable only if the |
| to code. |
Default Value | - |
Success | OK |
Error | 1. Too few arguments |
| “Usage: set serial s1 modem |
| Type ‘set serial s1 modem |
| Note: There is no validation on the country/region code value. |
To View Country or Region Code:
Command Syntax | show serial modem country code |
| This command is supported on s1 only. |
Description | Displays the supported country/region codes for this product. |
Default Value | - |
Success | OK |
Error | 1. Too few arguments |
| Possible value(s) are |
| configuration |
| |
| country/region code |
| |
| statistics |
Country or Region Codes – A list of thcountry or region code settings for the countries/regions that Multi- Tech currently supports is available on the
http://www.multitech.com/PRODUCTS/Categories/External_Device_Networking/global_modems/configuration.asp #chart
13 |