PAGE 30 — EM120P/S HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #6 (09/15/11)
DRUM HEAD SEALS
There is 1 set of drum head seals (Figure 35) that will require
lubrication. Lubricate the grease fitting for each drum seal

after each use

using any grade lithium base grease. Apply
grease until visible inside of mixing drum (over grease).
This will purge seal system of contamination.
MAINTENANCE (MIXER)
DRUM BEARING BRACKET LUBRICATION
There is 1 set of drum bearing brackets (Figure 36) that will
require lubrication. These brackets are intended to make
the drum rotate freely. Lubricate the grease fitting for each
drum bearing bracket

every month or when the drum

becomes difficult to position

using multi-purpose grade
grease.
CAUTION — Lubricate Grease Fittings

Failure

to lubricate the drum bearing grease fittings
eriodically will cause the dumping mechanism to stiffen,
making the mixing drum hard to dump.
BALL SOCKET AND CLAMP FACE MAINTENANCE
1. If the towing vechicle is equipped with a ball socket,
smear socket periodically with multi-purpose grease.
This will keep the ball socket well lubricated.
2. Periodically oil

pivot points

and

clamp face

surfaces
of coupler with SAE 30 WT. motor oil.
3. When parking or storing your mixer. Keep the coupler
off the ground so dirt will not build up in the ball socket.
HYDRAULIC OIL FILTER
Replace hydraulic oil filter (Figure 37) every 500 hours.
Hydraulic tank capacity is 12 gallons (45 liters). Refill with
any of the following hydraulic oil types. Shell Tellius 68,
Mobil DFE26 or Texaco Rand HDC.
WHEEL BEARINGS
1. After every 3 months of operation, remove the hub dust
cap and inspect the wheel bearings (Figure 38). Once a
year, or when required, disassemble the wheel hubs remove
the old grease and repack the bearings forcing grease
between rollers, cone and cage with a good grade of high
speed wheel bearing grease (

never

use grease heavier
than 265 A.S.T.M. penetration (“No. 2.”)
Figure 35. Grease Fittings (Drum Head Seals)
GREASEFITTING
ANDCAP
DRUMHEAD
SEALS
GREASEFITTING
ANDCAP
Figure 36. Grease Fittings (Dumping Mechanism)
GREASEFITTING
ANDCAP
DRUMBEARING
BRACKET
GREASEFITTING
ANDCAP
Figure 37. Hydraulic Oil Filter
Figure 38. Wheel Hub and Bearings