PAGE 18 —GB3LED LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (03/18/14)
STORAGE
1. Loosen the lower T-handle by turning handle
counterclockwise (Figure 16). Push down on mast
until mast is fully inserted into mast housing. Tighten
T-handle fully.
Figure 16. Lowering the Mast
2. Unhook the cable from the washer eyelet.
3. Unzip the zipper on the protective cover (Figure 20),
and pull down cover over balloon/lamp assembly.
Figure 17. Unzipping the Protective Cover
LOWER
T-HANDLE
ZIPPER
PROTECTIVE
COVER
OPERATION
4. Unhook lamp AC power cable from washer eyelet
(Figure 11). Fully zip protective cover and fold velcro
tab in place (Figure 18).
Figure 18. Zipping the Protective Cover
5. Loosen upper T-handle by turning counterclockwise
and lift lamp assembly from mast.
6. Store lamp assembly enclosed with its protective
cover (Figure 19) in a safe location where it will not
be damaged.
Figure 19. Storing Lamp Assembly
VELCRO
TAB
AC-POWER
CABLE
PROTECTIVE
COVER
PROTECTIVE
COVER