PAGE 16 — HBC19A/HBC25A REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #4 (03/30/09)
HBC19A/HBC25A — NAMEPLATE AND DECALS
1
5
HBC19A

OPERATINGINSTRUCTIONS

1.Placerebar in rebar holder. Rebar must rest fully
withintheblades.
2Adjust spacing bolt so it holds rebar flush against
stationarycuttingblock.
3.Tightenspacing bolt and jam nut to hold rebar in place.
4.Placeprotective cover in the upright position.
5.Pressand hold ON/OFF switch to begin cutting
procedure.
6.Continueholding ON/OFF switch until cutting rod
completescuttingcycle.
7.Cutterrod will retract automatically at end of
cuttingcycle.
8.Neveruse worn or damaged blades. Replace as
needed.
9.Periodicallyinspect oil level and electric motor brushes.

WARNING

2
3
4
MODELSERIALNO.
HBC25A
Keephandsclearwhile
machineisoperating.
WARNING
Topreventinjuryfromflying fragments.
1.Alwayswearsafetygoggles and full face
shield.
2.Keepbystandersaway from machine
whencutting.
3.Useextremecaution when cutting pieces
8”lengthorshorter.
4.Steelbarmust be fully seated within
cutterbladesbeforecutting.
5.Alwaysadjustandtighten spacing bolt
beforecutting.
6.Keepfingersaway from cutting edges
duringoperation.
7.Topreventelectricalshock, do not use
cutterwhendamp.