Multiquip HS62 Cam .The V-belt should remain in tension, Into the proper tensioning position

HS62 CUT-OFF SAW — SAW ASSEMBLY INSTRUCTIONS

Reverse the cutting arm 180 degrees as shown in the Figure 19, and re-tension the V-belt by turning the belt tensioning

cam .The V-belt should remain in tension.

Fully tighten the three nuts and washers	that lock the V-belt
into the proper tensioning position.

Figure 19. Reversing the Cutting Arm

Re-attach the cover guard	with the 2 cap screws		,
and reconnect the guard adjustment knob		.

Figure 20. Re-attaching Cover Guard

PAGE 20 — HS62 CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #5 (09/12/05)