Multiquip J B operation manual Engine Operation, Blade Pitch Quick Pitch handle, Gearbox Oil Level

B-SERIES TROWEL — INSTRUCTIONS

Blade Pitch — Standard Handle

The pitch control on machines equipped with the standard handle is a big star-wheel knob located at the operator end of the main handle tube. Pitch is controlled by turning the knob. Clockwise for increased blade pitch, counter-clockwise for decreased blade pitch.

Engine Operation

Check the oil level before starting the engine.

Because of the number of engine options, please refer to engine owner’s manual for specific instructions regarding engine operation.

Blade Pitch — QUICK PITCH™ handle

Pitch is controlled on machines with this option by a T-shaped lever located on the top of the main handle tube. To change the blade pitch, pull the locking control up to the T-handle. Pulling the handle towards the operator will increase blade pitch. Pushing the handle away from the operator will decrease the blade pitch. See page 8 for adjustment.

Electric Control Switch (electric motors only)

Located on the control handle, this switch transfers power to the electric motor when grasped.

Electric On-Off Switch (electric motors only)

Located on the handle, it is the main power control switch.

Gearbox Oil Level

Check the gearbox oil level daily.

Check the gearbox oil level by removing the plug located on the side of the gearbox. It will be clearly marked by the “check” decal (see Machine Decals section). Take care when removing plugs

on the gearbox, there are two of them. Removal of the bottom-most plug (DRAIN PLUG) will drain the oil. The level should be up to the bottom of the fill plug hole, located approximately half way up the side of the gear box. If needed, refill with specifically formulated gearbox lubricant (P>N> 10139) or ISO 680 oil.

Operation

The following steps are intended as a basic guide to machine operation, and are not to be considered a complete guide to concrete finishing. We suggest that all operators (experienced and novice) read “Slabs on Grade” published by the American Concrete Institute, Detroit, Michigan. Read the “Training” section of this manual for more information.

1.Check oil levels in the engine and gearbox.

2.Check to make sure that the fuel control valve is on and fuel is in the tank.

3.Set safety kill switch (if equipped with centrifugal type clutch) to ON position.

4.Set throttle to idle position.

PAGE 12 — B-SERIES TROWEL — PARTS & OPERATION MANUAL — REV. #1 (12/03/01)