Multiquip MC94S manual MC94P/S Concrete Mixer Initial START-UP GAS Engine

MC94P/S CONCRETE MIXER — INITIAL START-UP (GAS ENGINE)

Starting the Engine (Gasoline Only)

The following steps outline the procedure for starting the engine. Depending on the type of engine employed in the mixer the steps may vary slightly. If your mixer has an electric motor disregard this section.

1.Move the fuel shut-off lever (Figure 10) to the ON position.

Figure 10. Fuel Shut-OFF Lever

4.Turn the engine switch (Figure 13) to the ON position.

Figure 13. Engine ON/OFF Switch

5.Located at the rear of the mixer frame is the main start/ stop button (Figure 14). Pull this button outward to start the engine.

2.To start a cold engine, move the choke lever (Figure 11) to the CLOSED position.

Figure 11. Choke Lever

3.Move the throttle lever (Figure 12) away from the slow position, about 1/3 of the way toward the fast position.

Figure 14. Engine Start/Stop Button

6.Pull the starter grip (Figure 15) lightly until you feel resistance, then pull briskly.The drum should be rotating at this time.

Figure 15. Starter Grip

Figure 12. Throttle Lever

MC94P/S CONCRETE MIXERS — OPERATION AND PARTS MANUAL — REV. #8 (03/06/09) — PAGE 21