Multiquip manual MT-74FA Controls and Components, MT-74FA Rammer

MT-74FA — CONTROLS AND COMPONENTS

Figure 2. MT-74FA Rammer

Figure 2 shows the location of the controls and components for the MT-74FA Tamping Rammer. The functions of each control is described below:

1.Throttle Lever – Controls engine speed and the tamping action of the rammer.

2.Engine Stop Switch – Controls the starting and stopping of the engine. Switch must be in the "ON" position when starting the engine.

3.ChokeLever– Used when starting the engine.Normally used in cold weather conditions. In cold weather turn the choke lever to the fully closed position, in warm weather set choke lever half way or completely open.

4.Fuel Shut-OffValve – Supplies fuel from the fuel tank to the engine.To begin fuel flow move the fuel shut-off valve downward.

5.Oil Bath Fill Plug – Open this plug to add oil to the oil bath reservoir.

6.Drain Valve – Open this valve to remove oil from the bellows.

7. Pre-Cleaner – Pre-cleans (first stage) dirt and other debris from entering the engine.

8.Foot – Laminated wood with tempered steel plate for superior shock absorption.

9.Oil Level Sight Glass – Indicates the level of oil in the oil bath reservoir.

10.RecoilStartingHandle –Usedwhenstartingtheengine. Pull starter handle sharply and quickly, then return starter handle to starter case before releasing.

11.Fuel Tank/Cap – Poly fuel tank to avoid rust and corrosion, remove this cap to add gasoline.

12.Engine Air Cleaner – Prevents dirt (second stage) and other debris from entering the engine.

13.Bellows – Reservoir for oil bath.

14.Handle – To operate rammer, grip handle assembly firmly on both sides.

15.Muffler– Used to reduce noise and emissions.

16.Spark Plug – Provides spark to the ignition system, replace with engine manufactures recommended type spark plug.

17.Nameplate– Displaysinformationregardingtherammer.

PAGE 14 — MT-74FA — OPERATION AND PARTS MANUAL — REV. #3 (11/08/07)