Multiquip manual MT-84F Basic Engine, Robin EH-12-2D Engine Controls and Components

MT-84F — BASIC ENGINE

Figure 3. Robin EH-12-2D Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers Engine manual for instructions & details of operation and servicing.

1.	Secondary Air Cleaner – Prevents dirt and other debris
	from entering the fuel system. Remove wing-nut on top of
	air filter cannister to gain access to filter element.
2.	Choke Lever – Used when starting the engine. Normally
	used in cold weather conditions. In cold weather turn the
	choke lever to the fully closed position, in warm weather
	set choke lever half way or completely open.
3.	Spark Plug – Provides spark to the ignition system. Set
	spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch). Clean
	spark plug once a week.
4.	Muffler – Used to reduce noise and emissions.

5. Recoil Starter (pull rope) – Manual-starting method. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

6. Engine ON/OFF Switch – Controls the starting and stopping of the engine. Switch must be in the "ON" position when starting the engine.

Operating the engine without an air filter, with a damaged air filter,

NOTEor a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER

operate the engine with the muffler removed.

MT-84F — OPERATION & PARTS MANUAL — REV. #2 (06/30/05) — PAGE 15