MTR-35HS — CONTROLS AND COMPONENTS
Figure 1. MTR-35HS Rammer
Figure 1 shows the location of the controls and components for the MTR-35HS Tamping Rammer.The functions of each control is described below:
1.Throttle Lever – Controls engine speed and the tamping action of the rammer.
2.Engine Stop Switch– Controls the starting and stopping of the engine. Switch must be in the "ON" position when starting the engine.
3.ChokeLever– Used when starting the engine.Normally used in cold weather conditions. In cold weather turn the choke lever to the fully closed position, in warm weather set choke lever half way or completely open.
4.Fuel
5.Grease Fill Plug – Open this plug to add oil to the oil bath reservoir.
6.FuelValve – Open this valve to remove excess fuel from the carburetor or crankcase.
7. Pre- Cleaner –
8.Foot– Laminated wood with tempered steel plate for superior shock absorption.
9.Recoil Starting Handle
10.Fuel Tank/Cap – Poly fuel tank to avoid rust and corrosion, remove this cap to add gasoline.
11.Engine Air Cleaner – Prevents dirt (second stage) and other debris from entering the engine.
12.Handle – To operate rammer GRIP handle assembly firmly on both sides.
13.Muffler– Used to reduce noise and emissions.
14.Spark Plug – Provides spark to the ignition system, replace with engine manufactures recommended type spark plug.
15.Nameplate– Displaysinformationregardingtherammer.
16.Grip – When transporting the rammer, carry it by griping the handle.
17.Oil Tank – Fill oil tank with
18.Dust Sleeve – Prevents dust and debris from entering into the spring cylinder.
