Multiquip SP2S13H20, SP2S20H20, SP213H20 MQ SP2 Slab SAW Rules for Safe Operation, General Safety

MQ SP2 SLAB SAW — RULES FOR SAFE OPERATION

General Safety

zALWAYS read, understand, and follow procedures in Operator's Manual before attempting to operate equipment.

zALWAYS be sure the operator is familiar with proper safety precautions and operating techniques before using the saw.

zNEVER leave the machine unattended while running.

zBlock the unit when leaving or when using on a slope.

zALWAYS check to make sure that the operating area is clear before starting the engine.

zMaintain this equipment in a safe operating condition at all times.

zALWAYS stop the engine before servicing, adding fuel and oil.

zNEVER run the engine without the air filter. Severe engine damage could occur.

zALWAYS service air cleaner frequently to prevent carburetor malfunction.

zAVOID wearing jewelry or loose fitting clothing that may snag on the controls or moving parts, this can cause a serious injury.

zALWAYS keep clear of rotating or moving parts while the saw is in operation.

zALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.

zNEVER use accessories or attachments which are not recommended by the manufacturer for this equipment. Damage to the equipment and/or injury to user may result.

zKeep all inexperienced and unauthorized people away from the equipment at all times.

Diamond Blade Safety

zUse appropriate steel centered diamond blades manufactured for use on slab saws.

zExamine blade flanges for damage, excessive wear and cleanliness before mounting blade. Blade should fit snugly on the shaft and against the inside/outside blade flanges.

zEnsure the blade is marked with an operating speed greater than the blade shaft speed of the saw.

WARNING

ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.

zOnly cut the material that is specified by the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to the material being cut.

zALWAYS keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.

zEnsure that the diamond blade does not come into contact with the ground or surface during transportation. DO NOT drop the diamond blade on ground or surface.

zThe engine governor is designed to permit maximum engine speed in a no-load condition. Speeds that exceed this limit may cause the diamond blade to exceed the maximum safe allowable speed.

zEnsure that the blade is mounted for proper operating direction.

WARNING

ALWAYS check to make sure that the operating area is clear before starting the engine.

MQ SP2 SLAB SAW — PARTS & OPERATION MANUAL — REV. #7 (09/08/06) — PAGE 11