![](/images/new-backgrounds/1010550/1055031x1.webp)
control box installation
Connecting SW-1WOPA Float Switches to Control
Box
1.Remove the float switch input connector housing, then route the float switch wires through the cable gland on the control box. Attach the wires of the float switch to the terminal block as indicated by Table 6 and Figure 8.
Table 6. Dual Float switch Connections
Float | Terminal | Wire | |
Switch | Block No. | Color | |
Start | Black | ||
White | |||
| |||
Stop | Black | ||
| White | ||
|
2.Tighten the connector housing to ensure a tight fit between the cord and the connector body. This will prevent the cable from pulling out of the terminal block and also prevent moisture from entering the control box.
3.Determine the tether length of the float switch wires then secure float switch wires to pump discharge hose. See Figure 3 and Table 3 to determine the pumping range.
page 16 — st4/ST6 series submersible pumps • operation AND PARTS manual — rev. #1 (11/12/13)