page 12 — WM45HCe pLaSTeR/MORTaR MIXeR • OpeRaTIOn and paRTS ManuaL — Rev. #0 (02/04/13)
General infOrMatiOn

geneRaL

The MQ Model WM45HCE plaster and mortar mixer is
shipped completely assembled and has been factory tested.
The drum batch capacity of this mixers is between 1.5 and
2.5 bags. With proper care it will give continuous service
year after year.
This mixer is powered by a Honda GX160 gasoline engine.
The shaft of the engine is attached to a main gear via a
pinion gear. As the main gear rotates it causes the paddle
shaft to rotate.

Before Starting

Before starting the engine, read the engine owner's manual
and thoroughly understand the safety information.
Check the items listed below:

Oil Levels

Be sure to check the oil levels in the engine and engine
reduction unit before starting the unit (gasoline model only).

Hardware

Check all hardware on the mixer before starting. Periodically
inspect all hardware. Loose hardware can contr ibute to
early component failure and poor performance. Use the
torque char t below as a general guideline and keep all
hardware tight:
HaRdWaRe dIa TORQue (lb./ft.)
5/16"- 18 24
3/8" - 24 37
1/2" - 13 39
1/2" - 13 (Grade 8) 90

engine Care

For care and operation of the Honda engine, refer to the
maintenance procedures in this manual and the engine
manufacturer’s operating instructions furnished with the
engine. We recommend draining and refilling the engine
crankcase at least every thir ty hours of operation. Check
the engine oil level daily.