![HOW TO START ENGINE](/images/new-backgrounds/84434/8443431x1.webp)
OPERATION
HOW TO START ENGINE |
| WARNING: To prevent an acci- | ||
WARNING: The blade will rotate |
| dent, make sure the drive lever is | ||
| in the DISENGAGED position. | |||
when the engine runs. |
| When the drive lever is in the EN- | ||
IMPORTANT: Before you start the engine, |
| GAGED position, do not start the | ||
| engine. | |||
operate the engine stop lever several | 6. Some models have a primer button on the | |||
times. Make sure the engine stop cable | ||||
| front or side of the engine (Figure 13). Ev- | |||
moves freely. |
| |||
| ery time you push the primer button, wait | |||
|
| |||
NOTE: The engine design does not include |
| two seconds. For the number of times re- | ||
a throttle control or an engine speed ad- |
| quired to push the primer button, see the | ||
justment. The engine is set at the best |
| engine manufacturer’s instructions. | ||
speed for cutting grass, bagging grass, |
|
|
| |
|
|
| ||
and for extended engine life. |
|
|
|
1.Check the oil.
2.Fill the fuel tank with regular unleaded gas- oline. Make sure the gasoline is clean. Leaded gasoline will increase deposits and shorten the life of the valves.
| NOTE: Do not use gasohol or methanol. Do |
|
|
|
|
| |
| not use premium unleaded gasoline. |
|
| Primer Button |
|
| |
| WARNING: Always use a safety |
|
| Figure 13 |
| ||
|
|
|
|
| |||
|
|
|
|
|
| ||
|
|
|
|
|
| ||
| gasoline container. Do not smoke |
| NOTE: Do not use the primer button to | ||||
| when adding gasoline to the fuel |
| start a warm engine. |
|
| ||
| tank. When inside an enclosure, | 7. | Stand behind the mower. Hold the engine | ||||
| do not add gasoline. Before you | ||||||
|
|
| stop lever in the OPERATING position | ||||
| add gasoline, stop the engine and |
|
| ||||
|
|
| (Figure 12). |
|
| ||
| let the engine cool for several |
|
|
|
| ||
| 8. | Electric Start Models: Turn the ignition | |||||
| minutes. | ||||||
|
|
| key to the START position. Use short start- | ||||
3. Make sure the spark plug wire is connected |
|
| |||||
|
| ing cycles (15 seconds per minute). When | |||||
| to the spark plug. |
|
| the engine starts, release the ignition key. | |||
4. Electric Start Models: Make sure the bat- |
|
| If the engine will not turn over, charge the | ||||
|
| battery. See “How To Charge The Battery”. | |||||
| tery is connected to the wiring harness. |
|
| ||||
| 9. | ||||||
|
|
| |||||
5. Make sure the drive lever is in the DISEN- |
|
| |||||
| GAGED position (Figure 12). |
|
| between the upper and lower handles. | |||
|
|
|
|
| Rapidly pull the | ||
|
|
|
|
| return the |
|
|
| Hold the engine stop lever |
|
|
|
| ||
| 10. | If the engine does not start in 5 or 6 tries, | |||||
| in the operating position. | ||||||
|
|
| See the “Problem and Repair” Instructions. | ||||
|
|
|
|
|
|
| HOW TO OPERATE THE MOWER |
|
| WARNING: Check the condition |
|
| of the grass bag for wear or dete- |
|
| rioration. If worn or damaged, re- |
|
| place the parts only with ap- |
Drive Lever |
| proved factory replacement |
| parts. For replacement parts, | |
|
| |
Ignition Key |
| see the parts list in this book. |
| To completely fill the grass bag, operate the | |
|
| |
| Figure 12 | engine with the throttle control in the FAST |
| position. | |
16 |