MAINTENANCE
INSTALLATION
1.Slide the motion drive belt between the stack pulley and the belt guides (Figure 33). Install the motion drive belt on the top pulley of the stack pulley. Make sure the “V” side of the belt is against the pulley.
2.Push the motion drive belt through the opening between the steering plate and the engine plate.
3.Install the end of the motion drive belt around the drive pulley (Figure 30).
4.Tighten the belt guides at the drive pulley (Figure 31).
5.Put the belt around the idler pulley (Figure 30, Figure 35). Assemble the idler pulley. Fasten the idler pulley with the hex nut. Make sure the flat side of the belt is against the idler pulley. Also, make sure the belt is not twisted.
6.Make sure the motion drive belt is inside all the belt guides (Figure 30, Figure 31).
7.Attach the adjuster nut and shift link to the adjuster bracket with a hair pin (Figure 32). See “How To Adjust The Shift Lever”.
8.Attach the steering shaft assembly to the steering plate with two screws (Figure 34).
9.Attach the access panel (Figure 34).
10.Check the routing of the motion drive belt. Make sure the motion drive belt is installed correctly on the idler pulley. Make sure the steering shaft assembly in inside the motion drive belt (Figure 35).
11.Install the battery.
12.Before you use the unit, check the adjustment of the clutch. See the instructions “How To Check And Adjust The Clutch”.
13.Install the mower housing. See the instructions “How To Install The Mower Housing”.
Stack Pulley 
Steering Shaft
Assembly 
Motion Drive |
Belt |
Idler Pulley |
Figure 35
30 |
