BEFORE SWITCHING ON
Plug the accessory IEC mains lead into the rear panel socket, then the other end into a wall outlet.
Turn the volume control on the front panel to minimum (anticlockwise).
STARTING . . . .
Press the POWER button on the A308 amplifier - the blue power LED on the front panel will light indicating that the unit is ready for use. However, for about five sec- onds no sound will be heard from your speakers, and the red mute LED will light to confirm initial mute action.
Unless using your amplifier for
monitoring (see paragraph opposite ) ensure that the TAPE MONITOR button has not been pressed accidently, as other- wise no sound will be heard through the speakers.
Select the required audio input source by pressing an appropriate function button on the front panel or the remote control, and adjust the volume control to obtain the pre- ferred sound level.
OPERATION
TAPE RECORDING
To record, simply select the required source with the input selector button on the front panel. This source will now be routed to the A308’s TAPE RECORD output for record- ing by the external tape deck.
You will also be able to hear the selected source through the loudspeakers.
Note - adjustment of the volume control has no effect on the recording level.
OFF - TAPE MONITORING
In conjunction with a
The MONITOR button on the front panel can now be used to switch between the source signal and the recorded version allowing direct comparison.
The red LED just above the MONITOR button confirms that the tape monitor func- tion is operating.
Note that the recorded signal is selected when this LED is lit. On some
If in doubt, please refer to your tape deck operating manual.
Issue 3: March 2003 | A308 Integrated Amplifier | Instructions for use Page 7 of 9 |
|
|
|