CM-2S Stereo Condenser Microphone
USER GUIDE
Congratulations on purchasing the Nady CM-2S Stereo Condenser Microphone. This superior, versatile microphone provides the realistic spatial impact of a live sound field for many applications including stereo recording, ENG theater use, and FM stereo radio.
This manual covers the operation of the CM-2S microphone and the available optional accessories. To take full advantage of the superb features of your microphone, and to enjoy long and trouble-free use, please read this user’s guide carefully.
UNPACKING, INSPECTION, STORAGE AND TRANSPORT
Your CM-2S microphone was carefully packed at the factory, and the shipping carton was designed to protect the unit during shipping. Please retain this container in the highly unlikely event that you ever need to return your microphone for servicing.
STANDARD ITEMS SUPPLIED
•CM-2S Stereo Condenser Microphone
•Mic clip
•19" (0.5m) stereo cable (XLRF to 3.5mm stereo mini plug)
•10' (3m) stereo cable (XLRF to two 3.5mm mono mini plugs)
•Two 3.5mm (female) to 1/4" (male) phone plug adapters
•Foam windscreen
•Soft, protective leatherette pouch
•AA battery
•User guide
•Warranty card
OPTIONAL ACCESSORIES
•Camera Shoe Mount Adapter
•MST-5B Boom mic stand
FEATURES & OPERATION
The CM-2S uses a pair of closely-matched, wide range, condenser uni-directional (cardioid) elements, angled at 110° in an X/Y stereo configuration. It features superb channel separation; smooth, linear 30Hz-20kHz frequency response with a switchable low-frequency roll-off; On/Off switch, high SPL capability; extended dynamic range with ultra-low self noise; crisp, clear transparent audio; and internal battery operation. All this contained in a compact, lightweight design for easy camera mounting
The CM-2S has two unbalanced, in-phase, low impedance stereo outputs. The Left(+) signal is sent to Pin 2 and the Right(+) signal is sent to Pin 3. Both Left and Right use a common Ground(-) connection on Pin 1. Use the 19" stereo cable to connect to 3.5mm stereo inputs or the 10’cable to connect to two channels of your mixing console or recording equipment.
Placing the mic closer to the sound source will create a more pronounced stereo image while moving the mic further away will lessen the stereo image and result in more room noise. Placing a mic too close to a multi-voice source may result is some voices being more dominant than others. Experiment with placement for the best possible results. Use the low-cut filter switch to reduce stage floor noise and undesired low frequencies.
Before operating, install an alkaline or mercury AA battery by unscrewing, and sliding down, the lower portion of the handle to reveal the battery compartment. The CM-2S is only designed for battery use.
DANGER: DO NOT USE PHANTOM POWER WITH THE
CM-2S OR YOU COULD DAMAGE THE MICROPHONE.
Note: Low bias voltages (such as those used for mini-disc, DAT,
or analog recorders) will not harm the microphone.