S P E C I F I C AT I O N S
Power Amp Section | Tubes: 2 ea 6L6GC |
Power Output | 60 Watts @ 8Ω 5% THD; 40 Watts @ 4Ω 5% THD |
Speaker | Nady PowerDrive™ |
Preamp Section | Tubes: 3 ea 12AX7A |
Input Imp | 200KΩ |
Input Sens | Max clean 800Mv 1KHz; Max dist. 8Mv. 1KHz |
Line Out Inp | 600Ω |
Line Out Level | 1V Nominal |
Power Requirements | 115VAC/60Hz; 230VAC/50Hz |
Fuse | For 115 VAC: 3 AMP S.B. 250V; For 230 VAC: 1.5 AMP S.B. 250V |
Dimension | 18.3” x 9” x 17.5” (46.5 x 22.9 x 44.5 cm) |
Weight | 45.6 lbs. (20.7 kg) |
TUBE REPLACEMENT
Preamp Tubes 12AX7A — No adjustment required
Output Tubes 6L6GC — After replacing output tubes, output tubes bias voltage should be checked with Standby switch set to On, no signal input, and all controls set to minimum. If output tube bias voltage is not correct, amplifier will sound unusually distorted with mushy audio and output tubes may overheat. Normal output tube bias voltage should be — 52VDC on Pin 5 of all output tubes. For best results use matched output tubes.
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design
and appearance, are subject to change without prior notice.
7