![Speakers](/images/new-backgrounds/193011/19301111x1.webp)
INSTALLATION
Speakers
IR Sensor
Wireless Mic | Nady | |
| ||
|
IR Sensor
Nady
Speaker
IR Sensor
IR Sensor
(1)
(3) (2)
(1)Battery Compartment/Cover
(2)Power Switch
(3)Power LED Indicator
1. Transmitter
Unscrew and remove the Battery Compartment Cover (1) by sliding it down off the microphone to expose the battery holders. Insert 2 fresh AA alkaline batteries, NiMH rechargeable batteries, or the optional
(Note: Make sure the transmitter is off when changing the batteries.)
2. Operation
a. Slide the Power Switch (2) to the ON position. The Power LED Indicator (1) will light green, indicating that the transmitter is on. In the case of low batteries, the indicator will be off, indicating that the batteries should be replaced with fresh ones or the batteries should be recharged.
The
b. While speaking into the microphone, increase the corresponding Volume Con- trol (7) on the
[Note: Observe care in selecting volume, transmitter location and speaker place- ment so that acoustic feedback (howling and screeching) will be avoided.]
If there is no audio, check your speaker connections and verify proper impedance is being used. If there is still no audio, try turning the
6 | 11 |