| S P E C I F I C AT I O N S | |
POWER SPECIFICATIONS |
|
|
OUTPUT POWER (EIA 1KHz 1% THD) | 120W RMS @ 8Ω per side | |
|
| 150W RMS @ 4Ω per side |
ELECTRICAL SPECIFICATIONS |
|
|
INPUT SENSITIVITY | 500V RMS | |
INPUT IMPEDANCE | 50KΩ Unbalanced & Balanced | |
FREQUENCY RESPONSE (at 10dB below rated output power) | ........................................................20Hz~20KHz ±1dB | |
|
| 5Hz~50KHz ±3dB |
DISTORTION | <.1% | |
S/N RATIO | 100dB | |
GENERAL SPECIFICATIONS |
|
|
PROTECTIONS | Full short circuit, open circuit, thermal, ultrasonic, and RF | |
protection; stable into reactive or mismatched loads; ON/OFF muting; current limiter | ||
FRONT CONTROLS | Power switch, input level control for each channel | |
REAR PANEL CONTROLS | AC voltage selector switch | |
CONNECTORS | Power; IEC power cord jack | |
|
| Input: Active balanced XLR and 1/4” (6.3mm) TRS |
|
| Output: dual 1/4” speaker jacks |
POWER SUPPLY | 110V~120V 60 HZ | |
FUSE | 115V AC ~ 4A 250V FB | |
DIMENSIONS | 19” x 9.6” x 3.5” (483 x 244 x 89 mm) | |
WEIGHT | 16.6 lbs. (7.5Kg) |
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design
and appearance, are subject to change without prior notice.
7