Napoleon Fireplaces GD82PT-T, GD82NT-T manual Table of Contents

2

TABLE of CONTENTS

PG 2-5	INTRODUCTION	19	NIGHT LIGHTTM REPLACEMENT
	Warranty
	Dimensions	19-23	OPERATION / MAINTENANCE
	General Instructions
			Time Out
	General Information
			Fireplace Operation
	Care of Glass & Plated Parts
			Hand Held Remote Operation
5-9	VENTING		Dip Switch Number Chart
			Operating Instructions
	Vent lengths
	Venting Specifi cations	24	ADJUSTMENTS
	Air Terminal Locations
10-15	INSTALLATION/FRAMING		Pilot Burner Adjustment
			Venturi Adjustment
	Wall & Ceiling Protection	25	CONVERSION KIT
	Using Flexible Vent Components
	Fireplace Vent Connection	26-27	REPLACEMENTS
	Using Rigid Vent Components
	Gas Installation		Replacement Parts
	Restricting Vertical Vents
			Flexible Vent Kits
	Framing
			Terminal Kits
	Clearance to Combustibles
			Roof Terminal Kits
	Mantle Clearances and Enclosures
			Accessories
15	ELECTRICAL CONNECTION		Replacement Parts Diagram
	Hard Wiring Connections	28-29	TROUBLE SHOOTING GUIDE
	Schematic
16-18	FINISHING / SERVICING	30	SERVICE HISTORY
	Door Removal
	Burner Assembly Removal	31	NOTES
	Battery Replacement

Blower Replacement

Bowl, Mesh & Rock Replacement

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

WARNING

•Do not burn wood or other materials in this fi replace.

•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fi replace.

•Clothing or other fl ammable material should not be placed on or near the fi replace.

•Due to high temperatures, the fi replace should be located out of traffi c and away from furniture and draperies.

•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

•Even after the fi replace is out, the glass and/or screen will remain hot for an extended period of time.

•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the fl oor.

•Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace.

•It is imperative that the control compartments, burners and circulating blower and its passageway in the fi replace and venting system are kept clean. The fi replace and its venting system should be inspected before use and at least annually by a qualifi ed service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding mate- rial, etc. The fi replace area must be kept clear and free from combustible materials, gasoline and other fl ammable vapours and liquids.

•Under no circumstances should this fi replace be modifi ed.

•This fi replace must not be connected to a chimney fl ue pipe serving a separate solid fuel burning appliance.

•Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the

fi replace and to replace any part of the control system and any gas control which has been under water.

•Do not operate the fi replace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualifi ed service person.

•Do not strike or slam shut the fi replace glass door.

•This fi replace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

•Pressure relief doors must be kept closed while the fi replace is operating to prevent exhaust fumes containing carbon monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fi re.

W415-0583 / B / 05.23.07