Chapter 2 Configuring and Installing theSCXI Chassis
© National Instruments Corporation 2-9 SCXI Chassis User Manual
Figure 2-7. Address Setting Examples
SCXI-1000DCUnless you are using multiple chassis and need to configure one or more
SCXI chassis for a different address, you can skip this section, and the
SCXI chassis retains the factory-default address of 0.
You can configure the SCXI chassis for one of 32 different addresses so that
you can connect multiple SCXI chassis to the same control source. Three
jumpers that determine the chassis address are located behind the front
panel of Slot 0 just below the Reset button. The chassis address is the sum
of the values of all the jumpers. Figure2-8 shows examples of both the
factory-default setting of address 0 and the jumper settings for address 19.
Note SCXI-1000DC chassis through revisionC do not have address jumpers or switches
and respond to any address, but you cannot use them in multichassis systems. Revision D
and later chassis use jumpers on Slot 0 for chassis addressing.
ON
1
2
3
4
5
Chassis Default
Address = 0
ON
1
2
3
4
5
Address = 19