Index
© National Instruments Corporation I-5 PCI Serial for Windows Me/9x
straight-through cabling in a DTE-to-DCE
interface (figure), A-7
successful uninstallation (figure), B-4
system integration, by National
Instruments, E-1
T
technical support resources, E-1
termination, A-5
multidrop network using terminating
resistors (figure), A-5
time-saving development tools, 1-4
transceiver control modes (table), 4-2
transceiver mode, 3-4
setting with DeviceloControl, 4-4
transceiver mode control bytes (table), 4-4
transmission line using bias resistors
(figure), A-6
troubleshooting, C-1
diagnostic messages, C-2
forcing Windows to detect your
hardware,C-4
freeing an interrupt request level, C-1
resolving resource conflicts with legacy
boards, C-4
selecting conflict-free resources, C-2
two-port boards specifications, D-1
isolated two-port boards, D-1
two-wire devices, 2-15
connecting, 2-15
typical full-duplex system (figure), A-4
typical half-duplex system (figure), A-4
U
uninstalling serial hardware, B-1
uninstalling serial software, B-2
using FIFO buffers, 3-4
using serial hardware, 4-1
using this manual, 1-1
V
verifying hardware installation, 2-5
viewing or changing communication port
settings, 3-1
W
Web support from National Instruments, E-1
Win32 Overviews and Win32 Reference, 4-1
Win32 Software Development Kit, 4-1
worldwide technical support, E-2