Chapter 2 Function Reference — AO_Change_Para meter
NI-DAQ FRM for PC Compatibles 2-28
©
National Instruments Corporation
Legal values for paramValue depend on paramID. The following paragraphs list features
you can configure along with legal values for paramID with explanations and corresp onding
legal values for paramValue.
Reglitching
Every time you change the state of your DAC, a very small glitch is generated in the signal
generated by the DAC. When reglitching is turned off, glitch size depends on the binary
patterns that are written into the DAC; the glitch is largest when the most significant bit in the
pattern changes (when the waveform crosses the midrange of the DAC); it is smaller in other
cases. When reglitching is turned on, the glitch size is much less dependent on the bit pattern.
To change the reglitching parameter, set paramID to ND_REGLITCH.
If you are not concerned about this, you are likely to be satisfied by the d efault val ues NI-DA Q
selects for you if you do not call this function. The followin g table l ists de vices on which yo u
can change this parameter.
Voltage or Current Output
Some devices require separate calibration constants for voltage and current outputs. Setting
the output type to voltage or current for these devices causes the driver to use the correct
calibration constants and to interpret the input data correctly in AO_VWrite. To change the
output type, set paramID to ND_OUTPUT_TYPE.
Table 2-3. Reglitching Parameters for Permissible Devices
Device Type Per Channel
Selection Possible Legal Range for
paramValue Default Setting for
paramValue
AT-MIO-16X No ND_OFF and
ND_ON ND_ON
AT-MIO-16E-1
AT-MIO-16E-2
AT-MIO-64E-3
NEC-MIO-16E-4
PCI-MIO-16E-1
VXI-MIO-64E-1
VXI-MIO-64XE-10
Yes ND_OFF and
ND_ON ND_OFF
Caution: If you turn off reglitching on the AT-MIO-16X, timing problems that NI-DAQ cannotdetect might occur.