National Instruments 5441 specifications

NI 5441 Specifications

Unless otherwise noted, the following conditions were used for each

specification:

• Analog Filter enabled.

• DAC Interpolation set to maximum allowed factor for a given sample

rate.

• Signals terminated with 50Ω.

• Direct Path set to 1 Vpk-pk, Low-Gain Amplifier Path set to 2Vpk-pk,

and High-Gain Amplifier Path set to 12 Vpk-pk.

• Sample clock set to 100 MS/s.

Typical values are representative of an average unit operating at room

temperature (25 °C ± 3 °C). Specifications are subject to change without

notice. For the most recent NI 5441 specifications, visit

ni.com/manuals.

To access all the NI5441 documentation, including the NI Signal

Generators Getting Started Guide, which contains functional descriptions

of the NI 5441 signals, navigate to Start»Programs»National

Instruments»NI-FGEN»Documentation.

Hot Surface If the NI 5441 has been in use, it may exceed safe handling temperatures and

cause burns. Allow the NI 5441 to cool before removing it from the chassis.

CH 0........................................................................................................2

Sample Clock..........................................................................................14

Onboard Clock........................................................................................17

Phase-Locked Loop (PLL) Reference Clock.......................................... 17

CLK IN ...................................................................................................18

PFI 0 and PFI 1 .......................................................................................19

DIGITAL DATA & CONTROL (DDC)................................................ 20

Start Trigger............................................................................................22

Markers ...................................................................................................24