National Instruments 6008

NI USB-6008/6009 User Guide and Specifications 8 ni.com

Figure 5. Signal Label Application Diagram

Note Once you label the screw terminal blocks, you must only insert them into the

matching combicon jack, as indicated by the overlay label on the NI USB-6008/6009 device.4. Connect the wiring to the appropriate screw terminals.

1 Overlay Label with Pin Orientation Guides

2 Combicon Jack

3 Signal Labels

4 USB Cable

9006-BSU IN

I noi

cnufitluM

,tib-41 ,stupnI 8

23 latigiD 71

1golanA 6

Contents

Main USER GUIDE AND SPECIFICATIONS NI USB-6008/6009 Introduction Page Safety Guidelines Page Software LabVIEW SignalExpress for DAQ Hardware The following block diagram shows key functional components of the NIU SB-6008/6009. Figure 3. Device Block Diagram Setting Up Hardware Page I/O Connector Page Signal Descriptions LED Analog Input Analog Input Circuitry MUX Page Page Connecting Reference Single-Ended Voltage Signals Digital Trigger Analog Output Analog Output Circuitry DACs Connecting Analog Output Loads Minimizing Glitches on the Output Signal Digital I/O Digital I/O Circuitry Source/Sink Information I/O Protection Power-On States Static DIO Event Counter Reference and Power Sources +2.5 External References +5 V Power Source Specifications Analog Input Page Analog Output Digital I/O External Voltage Counter Bus Interface Power Requirements Physical Characteristics Safety Standards Voltages Hazardous Locations Environmental Electromagnetic Compatibility CE Compliance Waste Electrical and Electronic Equipment (WEEE) Where to Go for Support