National Instruments cFP-RTD-122, FP-RTD-122 Installing the FP-RTD-122, Installing the cFP-RTD-122

FP-RTD-122 and cFP-RTD-122 2 ni.com

Installing the FP-RTD-122

The FP-RTD-122 mounts on a FieldPoint terminal base (FP-TB-x),

which provides operating power to the module. Installing the

FP-RTD-122 onto a powered terminal base does not disrupt the

operation of the bank.

To install the FP-RTD-122, refer to Figure1 and complete the

following steps:

1. Slide the terminal base key to either position X, used for any

module, or position 1, used for the FP-RTD-122 module.

2. Align the FP-RTD-122 alignment slots with the guide rails on

the terminal base.

3. Press firmly to seat the FP-RTD-122 on the terminal base.

When the module is firmly seated, the terminal base latch locks

it into place.

Figure 1. Installing the FP-RTD-122

Installing the cFP-RTD-122

The cFP-RTD-122 mounts on a Compact FieldPoint backplane

(cFP-BP-x), which provides operating power to the module.

Installing the cFP-RTD-122 onto a powered backplane does not

disrupt the operation of the bank.

1 I/O Module

2Terminal Base

3 Alignment Slot

4Key

5Latch

6 Guide Rails