National Instruments NI PXI-8360, NI PCIe-8360 Hardware Installation

Hardware Installation

This chapter explains how to install the MXI-Express hardware.

The following are general instructions for installing the MXI-Express

cards. Consult your computer user manual or technical reference manual

for specific instructions and warnings.

Note The software for your MXI-Express kit is included with the current NI driver CD,

and is installed with the PXI platform software included as part of NI-VISA and other

NIdriver software products.

1. Power off your computer, but leave it plugged in while installing the

NI PCIe-8360. The power cord grounds the chassis and protects it from

electrical damage while you install the card.

Caution To protect both yourself and the computer from electrical hazards, your computer

should remain off until you finish installing the NI PCIe-8360.

2. Remove the top cover or access port to the PCI Express bus.

3. Select any available PCI Express expansion slot (x1 or wider).

Note The BIOS or motherboard may not support the NI PCIe-8360 in a slot intended for

a graphics card.

4. Locate the metal bracket that covers the cut-out in the back panel of the

computer for the slot you have selected. Remove and save the

bracket-retaining screw and the bracket cover.

5. Touch the metal part of the power supply case inside the computer to

discharge any static electricity that might be on your clothes or body.