©
National Instruments Corporation 2-1 PCI-4451/4452 User Manual
2
Installation and Configuration
This chapter explains how to install and configure your PCI-4451/4452
device.

Software Installation

Note Install your software before you install your PCI-4451/4452 device.
If you are using NI-DAQ, refer to your NI-DAQ release notes. Find the
installation section for your operating system and follow the instructions
given there. If you are using LabVIEW, LabWindows/CVI, or other
National Instruments application software, refer to the appropriate release
notes. After you have installed your application software, refer to your
NI-DAQ release notes and follow the instructions given there for your
operating system and application software package.

Hardware Installation

You can install the PCI-4451/4452 device in any available PCI expansion
slot in your computer. However, to achieve the best noise performance,
leave as much room as possible between the PCI-4451/4452 device and
other devices and hardware. The following are general installation
instructions, but consult your computer user manual or technical reference
manual for specific instructions and warnings:
1. Write down the PCI-4451/4452 device serial number in the
PCI-4451/4452 Hardware and Software ConfigurationForm in
AppendixC, Customer Comm unication, of this manual.
2. Turn off and unplug your computer.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of the computer.
5. Insert the PCI-4451/4452 device into a 5 V PCI slot. It should fit
snugly, but do not force the device into place.
6. Screw the mounting bracket of the PCI-4451/4452 device to the back
panel rail of the computer.
User.book Page 1 Tuesday, April 14, 1998 10:20 AM