NI Smart Camera I/O Accessory User Guide 8 ni.com
Specifications
This section lists the specifications of the NI Smart Camera I/O Accessory. These specifications are
typical at 25 °C, unless otherwise noted.
Note Refer to the NI 17xx Smart Camera User Manual for specifications about signals.

Power Requirement

Supply voltage....................................................... 24 VDC +20%/–15% (IEC 1311)
Current requirement............................................... Refer to the specification for your NI Smart Camera

Physical

Dimensions............................................................ 8.712 cm × 8.509 cm × 4.445 cm
(3.43in. ×3.35 in. ×1.75 in.)
Weight....................................................................98.1 g (3.46 oz)
Spring terminal blocks........................................... 6, 2 positions per block
Wire gauge.....................................................12–28 AWG wire
Camera connector..................................................15-pin D-SUB male connector
RS-232 connector.................................................. 9-pin D-SUB male connector
24VDC connector..................................................15-pin D-SUB female connector

Environmental

The NI Smart Camera I/O Accessory is intended for indoor use only.
Operating temperature................ ...........................0 to 55 °C
Storage temperature...............................................–20 to 70 °C
Humidity................................................................10 to 90%, noncondensing
Pollution Degree............................. .......................2
Approved at altitudes up to 2,000 m.

Safety

The NI Smart Camera I/O Accessory is designed to meet the requirements of the following standards of
safety for electrical equipment for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA 61010-1
Note For UL and other safety considerations, refer to the product label, or visit ni.com/
certification, search by model number or product line, and click the appropriate link in the
Certification column.