National Instruments TPC-2012 G

Fuse Replacement

Caution Do not replace the fuse unless it is damaged. Do not replace the fuse with a

differently rated fuse. For more information, see the fuse specifications in AppendixA,

Specifications.

Follow these steps to replace the fuse:

1. Remove the fuse cover.

2. Replace the damaged fuse with a new one.

3. Place the fuse cover back into position.

Contents

Main Page Important Information Warranty Copyright Trademarks Patents Compliance Compliance with FCC/Canada Radio Frequency Interference Regulations Determining FCC Class FCC/DOC Warnings Class A Conventions Contents Page General Information Introduction I/O Ports Cleaning System Setup Important Safety Information Setup Touchscreen Calibration + Panel Mounting Jumpers and Connectors Jumper and Connector Functions Page Page Page Page Dimensions System Kernel LCD Touchscreen Power Fuse Environment Safety Electromagnetic Compatibility CE Compliance Environmental Management Waste Electrical and Electronic Equipment (WEEE) RoHS B Serial Port Settings COM1/COM2/COM3 Connector Pinout COM4 Connector Pinout and Settings Page C Watchdog Timer Programming Overview Watchdog Timer Programming Page Page Example Programs Example 1: Enable the Watchdog Timer and Set 10 s as the Timeout Interval Example 2: Enable the Watchdog Timer and Set 5 Min as the Timeout Interval Example 3: Enable the Mouse to Reset the Watchdog Timer Example 4: Enable the Keyboard to Reset the Watchdog Timer Example 5: Generate a Timeout Signal without Timer Counting D Watchdog Timer Programming on WinCE DeviceIOControl Parameters Page How to Use the Control Codes IOCTL _WDT_ENABLE IOCTL _WDT_DISABLE IOCTL_WDT_STROBE IOCTL_WDT_GETTIMEOUT IOCTL_WDT_SETTIMEOUT IOCTL_WDT_REBOOT Programming Example Page E F Touchscreen Configuration Touchscreen Calibration G Fuse Replacement H Technical Support and Professional Services Index A C D E K L M N P W