USB-6008/6009 User Guide and Specifications 6 ni.com
Setting Up Hardware
Complete the following steps to set up the hardware:
1. Install combicon screw terminal blocks by inserting them into the
combicon jacks.
Note The USB-6008/6009 kit ships with signal labels. You can apply the signal labels to
the screw terminal blocks for easy signal identification.
2. Refer to Table3 and Figure 4 for label orientation and affix the
provided signal labels to the screw terminal blocks. Until the signal
labels are applied, you can insert the screw terminal blocks into either
of the combicon jacks. Refer to Figure 4 for more information about
signal label orientation.
Figure 4. Signal Label Application Diagram
Note Once you label the screw terminal blocks, you must only insert them into the
matching combicon jack, as indicated by the overlay label on the USB-6008/6009 device.
3. Connect the wiring to the appropriate screw terminals.
1 Overlay Label with Pin Orientation Guides
2 Combicon Jack
3 Signal Labels
4 USB Cable
3
2
2
1
4
3
90
06
-B
S
U
I
N
O
/
I
no
i
t
cn
uf
i
t
l
u
M
,
t
i
b-
41
,
st
up
nI
8
23 lat
i
g
iD 7
1
1gol
an
A6
1