Controls and Indicators
Depth Display
CORC121
Canceling Depth Alarms
A depth alarm warning can be temporarily canceled by pressing both and on the speedometer, simultaneously. After one minute, the alarm will resume if the condition that caused the alarm is not corrected. The operator can cancel the alarm as many times as necessary, until the condition is corrected.
The depth alarm warning will replace any information on the LCD screen. Canceling the alarm will restore the LCD to the original display. If not already in the depth mode, this would be a good time to switch to it (using M) in order to monitor water depth.
Depth Sounder Alarm Settings
NOTICE
The speedometer display must be in the depth display mode to change settings. Use the M to scroll to the depth display.
To change the depth sounder alarm settings M must be held down until the depth display changes to the alarm settings mode.
There are four menus in the alarm settings mode. Pressing and releasing the mode switch quickly will cycle through the different options.
Shallow Alarm
This alarm sounds when the water depth equals or is less than the set value.
The display will show “S X.X” which is the current setting for the