CHAPTER 3 ND-71548 (E)
Page 86
Issue 2
INSTALLATION PROCEDURE
2. EXTRACTION OF MOUNTED CIRCUIT CARDS
NAP-200-009
Sheet 2/13
Setting of Switch Positions and
Mounting of Circuit Cards
START
Removing the Card Stopper Referring to Figure 009-1, remove the card stopper
from the module.
Extracting Circuit Cards Referring to Figure 009-2, pull the card puller tabs
in the direction indicated by the arrow. The card
will release from the connector and can then be
removed.
Pull the card out about 50 mm (2 inches) from the
edge of the module so that it does not contact the
backplane connector.
END
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required