ND-71548 (E) CHAPTER 3
Page 89
Issue 2
INSTALLATION PROCEDURE
4. SETTING OF SWITCH POSITIONS ON CIRCUIT CARDS
NAP-200-009
Sheet 5/13
Setting of Switch Positions and
Mounting of Circuit Cards
START
Extracting the Circuit Cards from the
Module
Extract one circuit card requiring switch setting from
the module.
Place the extracted card onto the anti-static sheet.
Performing switch setting Set the required switches according to the Switch
Setting Sheets in the Circuit Card Manual.
Mounting of Circuit Cards After the switches have been set, partially insert the
card in the module. The card should extend about 50
mm (2 inches) from the module, and must not contact
the backplane connector. Refer to Figure 009-3.
END
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required