NEC 500, 700, 700M, 900 manual Figure A.1 Pin mini D-SUB Captive Signal Cable

Quick Start –continued

To attach the AccuSyncª monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Plug the end of the video signal cable of the monitor in the video signal connector of the computer. (Figure A.1). Tighten all screws.

For the Mac: Connect the Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the video signal cable to the Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.

4.Connect one end of the power cord to the AccuSync monitor and the other end to the power outlet (Figure C.1).

NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use section of this manual for proper selection of power cord.

5. Turn on the monitor and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of this UserÕs Manual.

Figure A.1

15-pin mini D-SUB

Captive Signal Cable

4

AS500700700M900FINAL2.p65 4 11/11/03, 1:45 PM