NEC FE750 Plus user manual Quick Start

Quick Start

To attach the MultiSync® FE750+™ monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.If necessary, install the display card into your system. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync FE750+ Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to the MultiSync FE750+ Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync FE750+ Macintosh cable adapter, call NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.

4.For download information on the Windows® 95/98/2000 INF file for your MultiSync monitor, refer to the References section of this User’s Manual.

5.Connect one end of the power cord to the MultiSync FE750+ monitor and the other end to the power outlet (Figure C.1).

6.Turn on the monitor (Figure D.1) and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

Figure A.1

3

Fe750+.wpc 5 11/1/00, 10:45 AM