|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Installation |
|
|
|
|
|
|
|
|
| E - 7 |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Installation
To attach the MultiSync LCD1525V monitor to your system, follow these instructions:
1.Turn off the power to your computer.
2.For the PC: Connect the
For the Mac: Connect the MultiSync LCD1525V Macintosh cable adapter to the computer (Figure B.1). Attach the
3.Remove connector cover and cable cover. Connect the
Place the Video Signal Cable under Clip A. Then place AC Adapter Cable under Clip B.
Replace connector cover and cable cover.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.
4.Connect one end of the power cord to the MultiSync LCD Series monitor and the other end to the power outlet (Figure D.1).
5.Turn on the monitor (Figure E.1) and the computer.
6.To complete the setup of your MultiSync LCD monitor, use the following OSM controls:
•Auto Adjust Contrast
•Auto Adjust
Refer to the Controls section of this User’s Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.
LCD1525E.PM5 | Page 19 | 99/06/09, 14:33 | PageMaker 5.0J |
