Pole Mount
1.Install a 1 ½” NPT pipe with male threads on lower end from the ceiling. Aftermarket mounting pans and accessories are available.
2.Thread locking ring onto pipe. Thread mount onto pipe and leave locking ring loose.
3.Attach interface plate (pn
4.Align interface plate into holes on mount, slide stand off bolts into slot and tighten. Add center locking Torx cap screw which attach secures the interface plate to the mount.
5.Attach the wire safety rope to the interface plate with the enclosed coupler.
6.Insert power and signal cables through pipe and out the top of the mount head to the projector and attach to projector.
7.Attach the I/O cover (pn
8.Adjust
9.Loosen tilt adjustment cap screw with enclosed tool and level the projected image to the screen. Tighten cap screw when a level image is achieved.
10.Loosen
11.If desired, add Kensington lock through the opening of the mount head, loop through cable end and attach to projector.
5880 Sheridan Boulevard, Arvada, Colorado 80003
Ph:
www.displaydevices.com