3. Projecting an Image (Basic Operation)

oSelecting a Source

The Source can be selected from the projector's control panel or from the remote control unit. Refer to the following guide to select Source.

1.

2.

Press Menu on the OSD control panel or on the remote control unit to display the Main Menu. Scroll to the Source menu using ▲or▼ and press Enter.

Note:

Return to the projected image by pressing Exit twice.Select the required source using ▲or▼ and press Enter.

Note:

If an XGA signal is not correctly recognized on NP4001, set "WXGA Mode" to Off. (see page 72).

To check if the signal is recognized, go to "Source" under "Information" menu. (see page 973)

39