CHAPTER 7 8-BIT TIMERS 50, 60, AND 61
User’s Manual U15331EJ4V1UD
130
Figure 7-7. Format of 8-Bit Timer Mode Control Register 60
Symbol <7> 6 5 4 3 2 1 <0> Address After reset R/W
TMC60 TCE60 0 TCL602 TCL601 TCL600 TMD601 TMD600 TOE600 FF4EH 00H R/W
TCE60 Control of TM60 count operationNote 1
0 Clear TM60 count value and stop operation (the count value is also cleared for TM50 in cascade connection
mode)
1 Start count operation (the count operation is also started for TM50 in cascade connection mode)
TCL602 TCL601 TCL600 Selection of timer 60 count clock
0 0 0 fX (5.0 MHz)
0 0 1
fX/22 (1.25 MHz)
0 1 0 fTMI
0 1 1 fTMI/2
1 0 0
fTMI/22
1 0 1
fTMI/23
Other than above Setting prohibited
TMD501 TMD500 TMD601 TMD600 Selection of operation mode for timer 60Note 2
× 0 0 0 Stand-alone mode (8-bit counter mode)
0 1 0 1 16-bit counter mode (cascade connection mode)
0 0 1 1 Carrier generator mode
× 0 1 0 PPG output mode
Other than above Setting prohibited
TOE600 Control of timer output
0 Output disabled
1 Output enabled
Notes 1. Since the count operation is controlled by TCE60 (bit 7 of TMC60) in cascade connection mode,
any setting for TCE50 is ignored.
2. The operation mode selection is set by a combination of the TMC50 and TMC60 registers.
Caution To manipulate TMC60, follow the setting procedure below.
<1> Set the TM60 count operation to stop.
<2> Set the operation mode and count clock.
<3> The count operation starts.
Remarks 1. fX: Main system clock oscillation frequency
2. f
TMI: External input clock frequency
3. The parenthesized values apply to operation at fX = 5.0 MHz.
4. ×: don’t care