NETGEAR GS104 manual Install the Switch and Connect 3Other Devices

Install the Switch and Connect the

3Other Devices

Apple G4	PC with	Server with GA622T	DSL
	GA302T	Adapter	modem
	Adapter

	10/100/1000 Mbps Gigabit Switch GS104
	On=10M, Blink=ACT
	1	2	3	4
Power	Green=FDX, Yellow=COL				1

	GigabitEthernet
2	3

					LOCAL
					10/100M
	8	7	6	5	4	3	2	1	INTERNET
1000M	100M								12VDC 1.2A
	Auto								OFF	ON
	Uplink
	4

GS104 4-Port 10/100/1000 Mbps	FVS318 Cable/DSL ProSafe VPN Firewall
Gigabit Ethernet Switch

1.Place the switch on a flat surface or hook onto the screws.

2.For each device, insert one end of an Ethernet cable into the port in the device and insert the other end into one of the Ethernet ports on the switch.

3.Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip).

The Power light

Power ACT, FDX, COL LED

1000M 100M

should light up.

LED

LED

10/100/1000 Mbps Gigabit Switch

GS104

Gigabit

Ethernet

1000M

100M

The corresponding

On=10M, Blink=ACT

Uplink

1

2

3

4

Auto

Link LED for each

Power

Green=FDX, Yellow=COL

1

2

3

4

connected and

Model GS104 4-Port 10/100/1000 Mbps Gigabit Ethernet Switch

powered device

should light and flash when activity occurs. If the connection is 1,000 Mbps or 100 Mbps, the LED in the RJ-45 jack will light up. If the connection is 10 Mbps, the 10M LED on the left side of the front panel wll light up.

Note: If any light doesn’t operate as indicated, go to the Troubleshooting section.