Optional SC module AF711F, ProSafe

The NETGEAR® ProSafe JFS524F 24 Port 10/100 Mbps Switch with 100FX provides you with a low-cost, high-performance network solution and are designed to support power workgroups operating at either 10 megabits per second (Mbps) or 100 Mbps.

With the ProSafe JFS524F 24 Port 10/100 Mbps Switch with optional 100FX module (AF711F), improvement is accomplished very easily, with no change to the desktop (the network interface cards or software and the network wiring). As a result, the performance upgrade and the applications it enables are obtained very quickly and at a low cost.

ProSafe

Description

	Solid	Valid Link on the port.
(Port Number)	Blinking	Packet transmission or receiving on the port.

The port is operating in 10 Mbps mode, if corresponding L/A LED is Solid or Blinking

SC Link/Act	On	Valid Link on the port
(Optional)	Blinking	Packet transmission or receiving on the port

Optional SC module (AF711F)

The modularity of ProSafe JFS524F switch provides you with a highly adaptable network. You can not only configure your network for 100FX fiber uplink, but, you also can opt to expand your network gradually and affordably as needed.

To install an optional 100FX SC module (AF711F) a. Unscrew and remove the module cover plate.

b. Insert the module (AF711F) into the slot, press firmly to seat the module. c. Tighten the module screws.

d. Power OFF and Power ON again if power has remained ON throughout the installation of SC module (AF711F).

ProSafe JFS524F switch is used as a desktop switch to build a small network that enables users to have 100 Mbps access to a file server. If a full-duplex adapter card is installed in the server or PC, a 200Mbps connection is possible on the port where the server or PC is completed.

Model JFS524F

IEEE 802.3i 10BASE-T Ethernet

IEEE 802.3 100BASE-FX Fast Ethernet

IEEE 802.3x Flow Control

Compatible with major network software, including Windows, NetWare, and Linux

Maximum