NETGEAR manual N300 Wireless Gigabit Router, Step, Installation Guide, JNR3000, on your router

Installation Guide

N300 Wireless Gigabit Router

JNR3000

Package Contents:

Step 1:	Step 2:	Step 3:
Unplug the power	Connect one end of the blue	Plug in, then turn on your modem.
to turn off your modem.	Ethernet cable to your modem,	Wait approximately 2 minutes
	and the other end to the Internet port
	on your router.	until your modem turns on.

If your modem has a battery backup, first remove and reinsert the battery before connecting your

modem to power.

DSL	(not included)
or Cable

		Laptop or Desktop
Internet	Ethernet cable	Computer

N300 Wireless Gigabit Router

Power adapter Ethernet cable

Modem

Step 4:

Connect the power adapter to the router, then plug it into an outlet. Wait until the wireless LED turns solid green.

If none of the LEDs turn on, make sure that the Power On/Off button is in the ON position (pushed in).

N300 Wireless

Gigabit Router

Step 5:

Connect the router to your computer.

Use another Ethernet cable to establish

a wired connection as shown in this diagram.

Optionally, connect wirelessly by using the preset wireless security settings located on the bottom label.

Step 6:

Open a browser.

If the Web page does not display, close and re-open the browser and enter http://routerlogin.net in the address bar, or check the “Troubleshooting” section in

the User Guide.