Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
Hardware Description
The WAG102 front and rear hardware functions are described below.
Front Panel
Figure
The following table explains the LED indicators:
LED | DESCRIPTION |
|
|
PWR | Power Indicator |
|
|
Off | No power. |
|
|
On | Power is on. |
|
|
TEST | Self Test Indicator |
|
|
Blink | Indicates self test, loading software, or system fault (if continues). |
| Note: This LED may blink for a minute before going off. |
100 LINK/ACT | Ethernet LAN Speed Indicator |
|
|
Off | Indicates no 100 Mbps Ethernet link detected |
|
|
Green Solid On | 100 Mbps Fast Ethernet link detected, no activity |
|
|
Green Blink | Indicates data traffic on the 100 Mbps Ethernet LAN. |
|
|
10 LINK/ACT | Ethernet LAN Link Activity Indicator |
|
|
Off | Indicates no 10 Mbps Ethernet link detected. |
|
|
Green Solid On | 10 Mbps Fast Ethernet link detected, no activity. |
|
|
Green Blink | Indicates data traffic on the 10 Mbps Ethernet LAN. |
|
|
Introduction |
v1.0, September 2005
