Network Equipment Technologies 100, 500 Starting PAP

10003137.00 Rev.1

2-8 Starting PAP

Starting PAP

To start the program:

1Either:

• from Program Manager, double-click on the icon; or

• from MS-DOS, change to the PAP directory and type one of the following:

PAPTS1 4 <Enter>

PAPTS1 3 <Enter>

PAPETSI <Enter>

PAPET SIB <Enter>

PAPDASS2 <Enter>

PAPDPNSS <Enter>

To change the COM port or baud rate settings, use the Port and/or Rate commands (see

Chapter 4 — Commands). Changes are saved when the program exits and will be used

each time the program starts.

Contents

Main Page Page Page Contents Introduction Installation The PAP screen Page Page About this user guide Audience Using this guide Technical assistance information Overview Filtering Buffering Display Basic Rate interface Page Page Installing PAP ISDN PAP ADLM Local PrimeSw itch Page Connecting PAP to an ISDN interface module Page 2Configure the ADLM V.24 as follows: Remote Remote and local Software installation Starting PAP Page Screen display Page Page Status line Page Layer 1 status line Primary Rate Basic Rate Page Examples Layer 1 status change Layer 2 frame Layer 3 message Item sources Page Entering commands Commands 4-3 Keys Key functions are shown below. Key Context Function Commands Page MakeF Med Mnem Mon MSDOS