NTI CRYSTALMON TFT/LCD MONITOR
7
Figure 2- Mount CM-WL17 to an arm or bracket
Wall Mount- Direct-To-Wall
If it is desired to mount the CRYSTALMON directly to the wall (model CM-WL17), two keyhole slots have been
provided on the back of the CRYSTALMON for this purpose (see Fig. 2).
CAUTION: Each fastener used for direct wall mounting must be rated for an object weighing at least 24
pounds.
Desktop Mount
If the CM-DT17 has been purchased, a desktop stand with installation instructions has been included. If using a
different desktop stand, secure the stand to the CRYSTALMON using either the 75mm or 100mm mounting holes,
as appropriate for the stand that has been purchased. The holes on the CRYSTALMON are intended for use with
M4 x 10MM screws. Use only M4 x 10mm screws (provided) for attachment to the CRYSTALMON. See the
instructions that come with the stand to complete the assembly.
12VDC
5A
-+
NTI NETWORK
TECHNOLOGIES
INCORPORATED
Tel:330-562-70701275 Danner Dr
Aurora, OH 44202
www.networktechinc.com
R
Fax:330-562-1999
DVI VGA
Power Supply
Bracket
Note: Use only
M4 x 10mm
screws (provided)
in 75mm or
100mm mounting
holes. Use of longer
screws may damage
the CRYSTALMON.
Hole pattern for 75mm mounting Hole pattern for 100mm mounting
Keyholes for mounting directly to the wall
Rear View of CRYSTALMON
Alternate Power Supply
Bracket location
cable restraint posts