New Balance NB447 Using the Water Resistant Connection Cover, Safety Information, under the clip

open the cord winder	pass the plug down
using the small tab	and through the cover
under the clip

wrap cord clockwise around the	close the cord winder
spool to reach desired length
	wind over
	20 inches!

pull the cord back up and over the spool

clip it on and go!

Using the Water Resistant Connection Cover

Your New Balance Ear Buds are also supplied with a silicon sleeve that can be used to cover the connection between the male headphone plug on the Ear Buds and the female headphone jack on the 15” or 36” cable. Use this connection cover if you routinely use your Ear Buds in extremely wet or damp conditions.

Stretch the connection cover over the plug of the Ear Buds as shown. After connecting the male plug of the Ear Buds to the female jack on the 15” or 36” cable. Slide the connection cover down so that it completely covers the plug and jack connection point to seal out excess moisture.

Safety Information

To protect your hearing, always start listening with the Volume Control of your music player set to a low level and gradually increase the volume to a comfortable listening level.

IMPORTANT! Listening at high volume for long periods of time can result in long-term hearing damage. For your safety, do not use headphones if they would prevent you from hearing warning sounds, such as while driving a car or motorcycle, riding a bike, etc.

NOTE: In extremely cold or dry air conditions you may notice a slight ‘tingling’ feeling in your ears when using in-ear headphones. This is the result of the build-up of static electricity in your body. This is normal and not an indication of any problem with your headphones.