SECTION VI
INSTALLATION OF MODEL 329 (WS) WITH OPTIONAL WOODEN SURROUND (KIT#PAKDFP34) See page 24, figure 7 for Clearances to Combustible Materials.
(1) When choosing the right location for your heater and mantel keep the following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic areas
and away from furniture and draperies.
CAUTION: The installation must conform with local codes ,or in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA54.
NOTE: See Section II for gas hookup and pressure check.
WAR NI NG : “Young children should be carefully supervised when they are in the same
room with the appliance.” “Children and adults should be alerted to the hazards of high
surface temperature and should stay away to avoid burns or clothing ignition.”
(2) Position screen before leaving heater unattended.
(3) Follow instructions for assembly of Wooden Surround (Mantel) supplied with the mantel.
TOOLS NEEDED: Medium Phillips screwdriver, tape measure, power drill, and 5/16" socket.
STEP 1: Lay out all components.
STEP 2: Assemble end panels A & B to top front rail C.
STEP 3: Stand end panels and top front rail into hearth.
NOTE: (Position back of end panels with back of hearth centering assembly from
each end). Install front screws first, then pull back towards the inside to square the
mantel. Install screws through back holes.
STEP 4: The owner must decide at this time if parts D, E, and F are to be wood or green. Beginning
with panel E stand chosen color face out on hearth flush against stop block located inside end panel A
and attach. Position the left end of top window D on top of E and attach. Slide panel F under the
right end of D and attach.
END PANEL B
END PANEL A
END PANEL
B
END PANEL A
E F
Page 29