New Buck Corporation 42 WARNING

LIGHTING INSTRUCTIONS

MI LLI VOLT VALVE (I TT)

FOR YOUR SAFETY, READ BEFORE LIGHTING

WARNING

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR

EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY,

OR LOSS OF LIFE.

A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow

these instructions exactly.

B. BEFORE LIGHTING smell around the appliance for gas. Be sure to smell next to the

floor because gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

♦ Do not try to light any appliance.

♦ Do not touch any electrical switch; do not use any phone in your building.

♦ Immediately call your gas supplier from a neighbor’s phone. Follow the gas

supplier’s instructions.

♦ If you cannot reach your gas supplier, call the fire department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob

will not push in or turn by hand, don’t try to repair it, call a qualified service technician.

Force or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water. Immediately call a qualified

service technician to inspect the appliance and to replace any part of the control system and

any gas control which has been under water.

Page 22

Contents

Main MODEL 42 MAY BE INSTALLED AS A ZERO CLEARANCE FIREPLACE OR WITH AN OPTIONAL WOODEN SURROUND Page TABLE OF CONTENTS Page SECTION I SAFETY INFORMATION WARNINGS CAUTION: 19. WARNING: INSTALLATION FOR MODEL 42 (ZC or WS) (E CHOOSING THE LOCATION FOR YOUR FIREPLACE: (ZC or WS) GAS LINES DRAFTS Page INSTALLING THE FIREBOX (ZC) FINISHING YOUR FIREPLACE (ZC) CLEARANCES (ZC) MANTEL PROFILES FOR ZERO CLEARANCE (ZC) CABINET MUST BE FOLLOWED Figure 5 Page 10 INSTALLATION OF MODEL 42 (WS) WITH OPTIONAL WOODEN SURROUND (KIT#PAKDM42) Page PRODUCING ADEQUATE VENTILATION NOTE: DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION VENTILATION AIR VENTILATION AIR FROM INSIDE BUILDING WARNING WARNING: Page WARNING: GAS CONNECTION WARNING: PLACEMENT OF LOGS FOR FP-42-ZC WARNING: GAS PRESSURE CHECK Page EMBER STOVE LOG SET PLACEMENT FOR MODEL 42 WARNING: All previously applied loose material must be removed prior to replacement. WARNING: parts specifically approved with this heater may result in property damage or personal injury. CR3329 CERAMIC LOG SET PLACEMENT FOR MODEL 42 WARNING: LIGHTING INSTRUCTIONS MI LLI VOLT VALVE (I TT) FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING Page TO TURN OFF GAS TO APPLIANCE PILOT BURNER CAUTION IGNITOR ELECTRODE THERMO-PILE THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDURE LIGHTING INSTRUCTION MODULATING VALVE (SIT) OR MANUAL VALVE (SIT) FOR YOUR SAFETY READ BEFORE LIGHTING WARNING LIGHTING INSTRUCTION TO TURN OFF GAS TO APPLIANCE CAUTION: CAUTION: WARNING: IMPORTANT : THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDURE LIGHTING INSTRUCTIONS SI T-M ILL IVO LT VALV E FOR YOUR SAFETY READ BEFORE LIGHTING Page CAUTION TO TURN OFF GAS TO APPLIANCE CAUTION: CAUTION: WARNING: Page FLAME CHECK E.S.B. LOG SET DX 2733 SPLIT LOG SET WIRING DIAGRAM WARNING: ROOM BLOWER INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT SAFEGUARDS WARNING: CLEANING CAUTION: BEFORE CLEANING OR MOVING THESE LOGS OR WARNING: TROUBLE SHOOTING WARNING CAUTION Page Page WARNING SERVICING REPAIR PARTS Page Page REPLACEMENT PARTS Page REPLACEMENT PARTS SIT MILLIVOLT NEW BUCK CORPORATION LIMITED WARRANTY MODEL FP-42-ZC